Xiaomi Poco M3 Pro 5G EDL Test Point Location (M2103K19PI)
The Xiaomi Poco M3 Pro 5G and its variants (Poco M3 Pro, M2103K19PG, M2103K19PI, M2103K19PY) are closely related models, but there may be minor regional differences between them. When looking for the EDL (Emergency Download) Test Point or performing any other technical procedures, the approach is similar for all these models.
Key Model Numbers:
Xiaomi Poco M3 Pro 5G (Global version)
M2103K19PG (Global variant)
M2103K19PI (Indian variant)
M2103K19PY (European variant)
These variants may have slight differences in hardware or firmware, but the EDL test point process and location are generally the same.
General Guide to Access EDL Mode on Xiaomi Poco M3 Pro 5G Models:
Disassemble the Phone:
Carefully remove the back cover using a plastic pry tool to avoid damaging it.
Disconnect the battery to ensure safety while working with the internal components.
Unscrew and remove any shields covering the motherboard.
Locate the EDL Test Points:
On Qualcomm-powered devices like the Poco M3 Pro 5G (which uses the Snapdragon 750G), the EDL test points are typically located near the Qualcomm processor or UFS storage chip.
These points may be unmarked, so you'll need to rely on online schematics or resources like Quick repair quckrepair.in for pinpointing the exact location.
On some Xiaomi devices, test points are often not labeled but can be identified through community-driven research and motherboard diagrams.
Short the EDL Test Points:
Use a small pair of tweezers or a jumper to short the test points.
While shorting the points, connect the device to a PC via USB cable.
If done correctly, the phone will enter EDL mode. Your PC should recognize the device for flashing purposes, using tools like QFIL or MiFlash.
Tools Required:
Non-conductive pry tools (for disassembly)
Small tweezers or jumper (to short the test points)
EDL cable (optional, but it simplifies the process)
Flashing tools like QFIL or MiFlash for firmware installation
Important Notes:
The test point process may require careful handling to avoid damage.
It's recommended to have a full backup of the device and be cautious about flashing firmware, especially if the device is still under warranty.
If you don't have access to the schematics for your exact model, forums like Quick repair quckrepair.in or Reddit can be helpful for finding details specific to your Poco M3 Pro model.
Would you like a specific guide for entering EDL mode with one of these variants, or are you interested in software tools for flashing?
